Moons of Madness: How to Fix the Satellite

Get the power cell from the table at the windows to the right (and add to Inventory). Insert it into the round slot by the entrance door.

There are three circuit boxes in the room, all against the curved wall with windows. You will access them from left to right.

Go to the circuit box on the left. Scan it with your Biogage to connect to it (hold RMB; then click LMB).

To operate the Biogage:
– Zoom in or out of the Biogage, press LeftAlt.
– Move the yellow square: A, W, S, D.
– Rotate the yellow square: LMB.
– Exit the circuit box: RMB.

Rotate the squares until you get this solution:

Exit and move to the second circuit box.

At the second circuit box, scan and connect with your Biogage (hold RMB; then click LMB).
This box needs two connections, one at a time.

First connection – left top connecting to the bottom right

Rotate the squares until you get this solution:

The PC

Before you do the second connection on this circuit box, exit the Biogage and go to the PC in the room, which will now be active.
You will need to access it to find the coordinates you need to align the satellite dish to.
Making the second connection on this circuit box will deactivate the PC again, so right now is the time to access it.
On the PC, go to the last (third) section from the top. It will show you this:

You need the numbers given at “chatterbox”. The first is the yaw and the second the pitch you will need to align the satellite dish to.

Second connection – left top connecting to the top right

Get back to the second circuit box and rotate the squares until you get this solution:

Exit the Biogage and move on to the third circuit box, which is now active.
The PC has lost power, but its job is done.

At the third circuit box, scan and connect with your Biogage (hold RMB; then click LMB).

Rotate the squares until you get this solution:

Exit the Biogage. You are ready to realign the satellite dish.

At the dish control panel (on a high platform) scan your ID card, then use your Biogage to connect to the device (the same way as before).

The satellite dish signal will be at 6%.

You need to use the coordinates you got from the PC to realign the dish.
Yaw: -158
Pitch: 43
Use A, D (horizontal) for Yaw, and W, S for Pitch (vertical) until you achieve this solution:

Once the right coordinates are shown, press T to use the radio.

Exit the Biogage. You are done here.